This week I start with creating 3D model of Voyager Space Probe. As I working on few jobs I don’t have to much time left for this project, but I wish to finish this model.
As you see on this preview renders I already made some parts like: Low and High Gain antennas, Extendable magnetometer boom, Radio scope termoelectric generator, Subreflector, Sun sensor, Plume shield, Spacecraft Bus and Propellent tank. There is much more parts to be done before Voyager will be finished. For modeling I use Cinema 4D R12 software.
About Voyager Space Probe
The Voyager is an American scientific program that launched two unmanned space missions, the probes Voyager 1 and Voyager 2. Voyager probes are designated to study just the planetary systems of Jupiter and Saturn, the space probes were able to continue their mission.
“Voyager 1″ in 2012 became the first human made object to enter the interstellar space. In 2016 Voyager 2 should also get to interstellar space and take some measurements like temperature of interstellar plasma.
Both of the Voyager have take large amounts of data about the gas giants of our solar system, and their orbiting moons. After 2025 probe will bi without power for instruments, and it will be just object in space. Voyager should be remembered, because it was bring as valuable data and it make record as furthest human-made object. And most important after more than 30 years this mission is still going.
Update: Voyager NASA Satellite is over, you can find more here: Voyager NASA Satellite